Ilari Specsheet
Back ] Up ] Next ]
[Ilari home]

The little house with the little man  
Jane and Ian home  

 

 

General

 
Name: Ilari (Inupiat word for jellyfish)
Former names: Mara Maru, Dragon
Designer: Graham Shannon
Builder: Dieter Pollack
Date launched: 1986
Description: Amazon 44PH cutter rigged round bilge steel sailboat with skeg hung rudder and modified fin keel
Dimensions: LOA: 44ft
  LWL: 37ft
  Beam: 13’8"
  Draft: 6’5"
Design Displacement: 30600 lbs.
Waterline to keel bottom: 84 inches
Depth sounder to keel: 48"
Ballast (internal lead) 10,000 lbs.
Stem to water: 60"
   

Rig

 
Rig type: Cutter
Mast Height: 56 ft above deck
Mast Height: base of mast to head 55’9"
Mast: Hood in-mast furling  

Shrouds/Stays:

 
Outer to mast tip: 3/8" (2)
Inner, to top spreader: 5/16 (4)
Inner to lower spreader: 3/8 (4)
Running backstays: 5/16 (2)
Headstay: 5/16"
   

Sails

 
Sail area: 1344 sq. ft
Main Hood, battenless in-mast furling
Staysail Hood
Foresail San Juan Yankee with Harken furling
Cruising chute  
Light Air drifter  
Storm staysail Staff
Storm trisail Staff

Headsail

 
Type: Harken roller furling
Jib furling rotation: clockwise
I: 56.25
J: 18.75
Jc = 18’9" (Tack to mast)
Max headstay length: 59’
Max sail luff: 57’1"
Tack above stem: 19"
Tack to front of track: 24’8"
Track length: 10’
   

Scantlings

 
Hull and deck material: Steel
Hull type: Round bilge hullform
Hull plating: 3/8"
Frames: 3/8" x 2 ¼" flat bar on 26" centres
Long stringers: ¼" x 1 ¼" on 12" centres
Keel: ¼" plating; sole is ½"
Skeg-mounted rudder and skeg: 3/16" plating
Deck and cabin top: 10 gauge plating on 3/8" x 2 ½" flatbar frames and ¼" x 1 ¼" stringers
Cabin sides and cockpit: 3/16" plating
Chain plates: stainless steel welded through deck to frames
Insulation: closed cell polyurethane minimum 1" except bilge; fiberglass over polyurethane in low areas
Surface finish: Devoe 235 epoxy coatings inside and out: one shot blasted surface
Through-hulls: Synthetic through-hulls and ball valves on below-water openings
   

Mechanical

 
Engine: Yanmar 4JH-HTE freshwater cooled, supercharged
Genset: Yanmar 3GM diesel, 7.5 kW
Transmission: KBW21, ratio 2.62:1, Kanzaki gear
Propeller: Maxprop 20"
Prop shaft diameter: 1 ¼"
   

Instrumentation

 

Communications

 
H.F. transceiver: Yaesu FT757GX
SSB: Icom IC M700
VHF: Icom M80
Weatherfax: Furuno 907
Handheld VHF: Motorola Triton MP+

Navigation

 
GPS: Trimble Navtrac XL
Handheld GPS: Magellan 3000
Radar: Raytheon R20
Compass: Sestral (Binnacle)
Autopilot: Comnav 2001S with wind interface and cockpit remote
Loran: Trimble
Depth: B&G Hecta, cockpit repeater
Speed/Wind: B&G Hornet, cockpit repeater
   

Electrical

 
12V and 110v systems (110v from shore power, genset, or inverter)  
Battery charger: Professional Mariner
Isolation transformer  
Batteries: 2 Banks, 480 amp hours
Inverter: 1200w Heart Interface
Separate battery for genset starting  
Separate battery for bow thruster  
   

Tankage

 
Water: 140 gallons in three tanks
Diesel: 150 gallons in 2 tanks
Waste: 25 gallon holding tank with discharge macerator pump and pump-out opening
Hot water tank  
monitoring: Tank Tender monitoring for water/waste; electric gauges for diesel
   

Entertainment:

 
Stereo: 4-speaker Pioneer KEH-P4400 with 6-CD CD-changer
   

Heads

 
Aft: Lavec toilet, shower with drain
Forward: Lavec toilet, separate shower with drain
   

Galley

 
Stove and oven: Force 10 4-burner
Freezer and Refrigeration  
Microwave  
   

Deck

 
Winches: Andersen and Lewmar
Deck wash  
2 deck storage boxes  
Cockpit lifting hoist  
Evinrude 2 hp outboard  
Yamaha 9.9 hp outboard  
Shakespeare TV antenna  
Monitor windvane  
Swim ladder  
Lifelines, fenders, dock lines, halyards, sheets  
2 propane tanks in ventilated lockers above deck  
Dodger, canvass awnings  
Covers: Windlass, cockpit winch, wheel & pedestal covers
   

Ground Tackle

 
Windlass: Anchormate (Electric) with deck foot switch
Anchor: 30kg Bruce w/ 240ft 3/8" chain
Extra anchor chain: 100ft 3/8"
Extra anchors: 20kg Bruce, 10kg Bruce
   

Miscellaneous equipment:

 
Achilles dinghy GT11 with aluminum floor boards and cover  
Boston Shipstrike clock and barometer  
Bow thruster: Westmar 2-blade with own battery
Mast Steps  
Spare propeller  
Washer/Drier  
Zincs on hull, propeller, bow thruster  
Full complement of spare parts  
Professional Mariner corrosion controller  
Window curtains  
Inside steering in Pilothouse with full instrument console  
Forced air heating/AC  
   

Water

 
Pressure water system, main pump and backup pump  
Power Survivor 35 watermaker  
   

Lighting

 
Cockpit floodlights  
Searchlight  
Strobe light at masthead  
Spreader lights  
Running lights, anchor light at masthead  
   

Survival/Safety Equipment

 
EPIRB 406 MHz  
4 life jackets  
Emergency tiller  
Bolt/cable cutters  
Givens 6-man liferaft  
Manual bilge pump  
Radar reflector  
Delta drogue  
4 survival suits  
Paratech Sea Anchor  
4 West Marine auto-inflatable PFDs with harnesses  
Jacklines  
Scuba gear, dry suit  
Axe  
Flares, horn, bell  
Automatic bilge pump  
   

 

 

 

Ilari Elevation ] Ilari Layout ] [ Ilari Specsheet ] Ilari Pics ] Ilari in April ]